Garmin TR-1 Gold 설치 지침 - 페이지 6

{카테고리_이름} Garmin TR-1 Gold에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 7 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 소유자 매뉴얼 (38 페이지), 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

Figure 11-a

Step Four:

Put cylinder Rod Eye block (item 31) down over the pin in the Rod Eye Mounting Bracket (item 4). See

Figure 11-a. Turn the Cylinder (item 34) so that the Fittings (item 35) point up (toward the top of the

motor). Line the hole in rear end cap of the Cylinder (item 34) with the hole in the top of the Stern Pivot

Pin (item 5). Slide the Clevis Pin (item 14) into the top hole of the Stern Pivot Pin. Line up the cross holes

and put the Large Hair Pin Cotter (item 12) through the cross holes in both Pins. See Figure 11.

NOTE: If for any reason you

need to disconnect the steering

actuator, pulling the large Hair

Pin Cotter and Clevis Pin will

disconnect them quickly.

Step Five:

Install the Hair pin (item 13) on the pin in the

Rod Eye Mounting Bracket (item 4) and against

the Rod Eye block (item 31). See Figure 12.

Figure 12

Page 6

Figure 11