Garmin TR-1 Gold 설치 지침 - 페이지 7

{카테고리_이름} Garmin TR-1 Gold에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 7 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 소유자 매뉴얼 (38 페이지), 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

the position of the Rod Eye block (item 31) on the end of the Cylinder shaft. The Cylinder shaft should turn

with your fingers if the Hex Jam Nut (item 33) is loose. (If the shaft does not turn freely enough, use a thin 1/4

Inch open end wrench at the shaft's wrench flats and loosen the hex jam nut.)

Do not use any tool on the cylindrical part of the Cylinder shaft. If the shaft gets scratched, bent, or dinged

the seal will fail.

With the cylinder properly adjusted, secure it by tightening the Hex Jam Nut against the Rod Eye after

putting a little thread lock between them. It is ready for plumbing the hydraulic hoses. We suggest you put

the original parts to the motor in a container and, carefully, store them.

Figure 14

Figure 13

Page 7

Step Six:

Adjust the cylinder travel

both directions.

Turn the motor hard over

to port. That will retract the

Cylinder rod into the Cylinder.

See Figure 13. Check that the

Cylinder rod is still free to

retract at least a little more.

Next turn the motor hard

over to starboard. That will

extend the Cylinder rod out

of the Cylinder. See Figure

14. Check that the Cylinder

rod is still free to extend at

least a little more. It should

have additional travel in both

directions. If it does not, adjust