Garmin TR-1 Gold Montaj Talimatları - Sayfa 7

Deniz GPS Sistemi Garmin TR-1 Gold için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Garmin TR-1 Gold 7 sayfaları. Throttle actuator
Ayrıca Garmin TR-1 Gold için: Kullanıcı El Kitabı (38 sayfalar), Temel Kullanım Kılavuzu (9 sayfalar), Hızlı Referans (2 sayfalar), Kurulum Talimatları (4 sayfalar), Owner Handheld Hızlı Referans (2 sayfalar)

the position of the Rod Eye block (item 31) on the end of the Cylinder shaft. The Cylinder shaft should turn

with your fingers if the Hex Jam Nut (item 33) is loose. (If the shaft does not turn freely enough, use a thin 1/4

Inch open end wrench at the shaft's wrench flats and loosen the hex jam nut.)

Do not use any tool on the cylindrical part of the Cylinder shaft. If the shaft gets scratched, bent, or dinged

the seal will fail.

With the cylinder properly adjusted, secure it by tightening the Hex Jam Nut against the Rod Eye after

putting a little thread lock between them. It is ready for plumbing the hydraulic hoses. We suggest you put

the original parts to the motor in a container and, carefully, store them.

Figure 14

Figure 13

Page 7

Step Six:

Adjust the cylinder travel

both directions.

Turn the motor hard over

to port. That will retract the

Cylinder rod into the Cylinder.

See Figure 13. Check that the

Cylinder rod is still free to

retract at least a little more.

Next turn the motor hard

over to starboard. That will

extend the Cylinder rod out

of the Cylinder. See Figure

14. Check that the Cylinder

rod is still free to extend at

least a little more. It should

have additional travel in both

directions. If it does not, adjust