Garmin Fusion Apollo MS-ERX400 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Garmin Fusion Apollo MS-ERX400에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Fusion Apollo MS-ERX400 20 페이지.
Garmin Fusion Apollo MS-ERX400에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄

Update Options

Select

, select the name of the device, and select SETTINGS > UPDATE.

ERX REMOTE: Updates the remote control from a stereo connected to the ETHERNET port or the Fusion

PartyBus network using a valid software update file on a USB flash drive connected to the stereo

Updates, page

10).

FACTORY RESET: Restores all settings to the factory default values.

Network Settings

Select

> SETTINGS, select the name of the remote control, then select NETWORK.

DHCP CLIENT: Sets the device as a DHCP client. This is the default setting for all devices that are not

configured to be a DHCP server.

STATIC IP: Allows you to set a static IP address for the device

GARMIN MARINE NETWORK: Allows the device to be used on a Garmin

and controlled by connected Garmin chartplotters.

RESET: Resets the network configuration on the remote control to factory defaults.

DETAILS: Shows information about the network configuration.

SAVE: Allows you to save changes to the network settings.

Setting the Device as a DHCP Client

This device is set as a DHCP client by default. When set as a DHCP client, the device is configured for use on a

network with a DHCP server. If no DHCP server is present on the network, the device assigns its own local IP

address after a short delay.

NOTE: Although the Fusion PartyBus devices can communicate with each other without a DHCP server on the

network, the devices take longer to connect to each other when you first turn them on. It is highly recommended

to have one properly-configured DHCP server on the network for the best results.

1 Select

> SETTINGS.

2 Select the name of this device.

3 Select NETWORK > DHCP CLIENT > SAVE.

Setting a Static IP Address

If the stereo is configured as a static IP, it is automatically assigned the IP address of 192.168.0.1. You can

change this IP address.

If the stereo is a DHCP client on the network and you do not want the DHCP server to automatically assign an

IP address to the stereo, you can set a static IP address.

NOTE: Every device on the network must have a unique IP address. If you select a static IP address that is the

same as the IP address on the network, the devices will not work properly.

1 Select

> SETTINGS.

2 Select the name of the remote control.

3 Select NETWORK > STATIC IP.

4 Select an option:

• To set the IP address, select IP, and enter the IP address.

• To set the subnet mask, select MASK, and enter the subnet mask.

NOTE: The subnet mask must match all other devices on the network to work properly. A typical subnet

mask is 255.255.255.0.

• To set the default gateway IP address, select GATEWAY, and enter the gateway IP address.

NOTE: The default gateway is typically set as the IP address of the DHCP server on the network.

5 Select SAVE.

General Settings

(Setting a Static IP Address, page

Marine Network so it can be viewed

(Software

9).