AEG F89078VI-S 일반 매뉴얼 - 페이지 36

{카테고리_이름} AEG F89078VI-S에 대한 일반 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG F89078VI-S 43 페이지. 18” fully integrated dish washer
AEG F89078VI-S에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

5.2

Cleaning the water intake fi lter

Clean the water inlet fi lter at regular intervals. After closing the delivery tap, un-

screw the ring nut (ref. A fi g. 5-01) on the water inlet pipe (using a pair of pliers,

if necessary) and delicately clean the fi lter, removing deposits or impurities. Then

fi rmly fi x the pipe by tightening the ring nut (ref. A fi g. 5-01) (use a pair of pliers,

if necessary).

5.3

Cleaning the spray arms

The spray arms can be easily removed for periodic cleaning of the nozzles, to pre-

vent possible clogging. Wash them under running water (at room temperature)

and carefully replace them in their seats, checking that their rotary movement

is in no way impeded; if this is not the case, make sure they have been mounted

properly.

Removing the spray arms

• To remove the upper spray arm (ref. A fi g. 5-02), unscrew the locking ring (ref.

B fi g. 5-02) by turning it clockwise. After cleaning, remount the spray arm in its

seat and tighten the locking ring by turning it anti-clockwise.

•

To remove the lower spray arm (ref. A fi g. 5-03), simply lift it up, pulling by the

central part (see fi g. 5-03). Then remount the lower spray arm into its seat and

push it down slightly until it click into place (see fi g. 5-03).

USER INSTRUCTIONS

Fig. 5-01

Rev 0.0