Garmin GSD 22 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Garmin GSD 22에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GSD 22 8 페이지. Marine radio apparatus ( marine sounder)
Garmin GSD 22에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (10 페이지), 적합성 선언 (1 페이지)
페이지 인쇄
Marine Network Wiring and Cables
Garmin Marine Network components use specialized Garmin Network cables. For some installations, it may be necessary to drill 1¼ in.
(32 mm) holes to route the connector end of the cables. Garmin rubber grommets are provided to cover the installation holes (see below).
Wiring instructions are found on the following pages. If you experience difficulty installing the GSD 22, contact Garmin Product Support
or seek the assistance of a professional installer.
The grommets may not be needed in some installations. The grommets do NOT create a waterproof seal. To create a waterproof seal, apply
marine sealant around the grommet and cable after installation. Additional grommets can be purchased from your Garmin dealer or direct from
Garmin. Be sure to test the system before installing the grommets.
Tools
•
Drill
•
1¼ in. (32 mm) paddle drill bit or hole saw
•
Utility knife
•
Marine sealant (optional)
To install a Cable Grommet and Cable:
1. Mark the location through which the Power/Date cable or the Garmin Marine network cable will be routed.
2. Use a 1¼ in. (32 mm) paddle drill bit or hole saw to drill the installation hole.
3. Refer to the diagram below for trimming instructions. Carefully trim the cable hole, as needed.
4. Route the cable to the GSD 22.
5. Spread the grommet apart at the split, and place it around the cable (see below).
6. Firmly push the grommet into the installation hole until it is seated.
7. Test the connection before applying marine sealant, as needed, to create a waterproof seal.
Cable hole for the Power/Data, Garmin Marine
Network, or GPS 7 Cable
Split
GSD 22 Installation Instructions