Garmin GSD 26 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Garmin GSD 26에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GSD 26 14 페이지. Professional sonar module
Garmin GSD 26에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (6 페이지)
Preparing the Cable
1 Remove the terminal block lid from the sounder.
2 Select an option:
• Feed a sensor cable through the small cord grip
• Feed a transducer cable through one of the large cord grips
terminal block area.
NOTE: Do not tighten the cord grip.
Connecting the Wires to the Terminal Block
Before you connect the wires, consult the wiring diagrams
proper wiring configuration for your transducer and the wiring tables
for specific examples of Garmin wire colors.
1 Connect the uninsulated section of each wire to the terminal block using a 3 mm flat screwdriver.
2 Connect the bare shield wire to one of the two ground posts under the terminal block using a #2 Phillips
screwdriver.
Securing the Wire Connections
1 After connecting the wires, use a 24 mm (1 in.) wrench to tighten the nut around the transducer cable.
When tightened correctly, you should not be able to pull the transducer cable out of the housing.
2 Insert a cord grip plug into each unused cord grip.
3 Replace and secure the terminal block lid on the sounder with a #2 Phillips screwdriver.
NOTE: The sounder does not operate when the lid is removed.
4
, and pull the cable into the terminal block area.
on the housing, and pull the cable into the
(Transducer Wiring Diagrams,
(Transducer Wire Color Tables,
page 6) to select the
page 11)
GSD 26 Installation Instructions