Garmin GSD 26 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Garmin GSD 26에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GSD 26 14 페이지. Professional sonar module
Garmin GSD 26에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄

Tools Needed

• Drill

• #8 (5 mm) drill bit for mounting surface

• 1

in. (32 mm) paddle drill bit or hole saw for mounting surface

• #2 Phillips screwdriver

• 3 mm flat screwdriver

• Cable ties (optional)

• Dielectric grease

• Wire cutter

• Wire stripper

• 1 in. (24 mm) and

• Marine sealant (optional)

Mounting the Sounder

Mounting Location Considerations

• The sounder must be mounted in a location where it cannot be submerged.

• The sounder must be mounted in a location with adequate ventilation where it will not be exposed to extreme

temperatures.

• The sounder should be mounted so that the LEDs are visible.

• The sounder should be mounted so that the power and network cables can be easily connected.

• The sounder should be mounted so that the transducer cable can be connected. If required, transducer

extension cables are available through your Garmin dealer.

Mounting the Device

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill

a clearance counterbore through only the top gel-coat layer. This will help to avoid any cracking in the gel-coat

layer when the screws are tightened.

Stainless-steel screws may bind when screwed into fiberglass and overtightened. Garmin recommends applying

an anti-seize lubricant to the screws before installing them.

Before you mount the device, you must select a mounting location and determine the mounting hardware

needed for the surface.

NOTE: Mounting hardware is included with the device, but it may not be suitable for the mounting surface.

1 Place the device in the mounting location and mark the location of the pilot holes.

2 Drill the appropriate pilot hole for one corner of the device.

3 Loosely fasten the device to the mounting surface with one corner and examine the other three pilot-hole

marks.

4 Mark new pilot-hole locations if necessary, and remove the device from the mounting surface.

5 Drill the appropriate pilot holes for the other three marks.

6 Secure the device to the mounting location.

in. (15 mm) wrenches

NOTICE

GSD 26 Installation Instructions