Garmin Forerunner 210 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Garmin Forerunner 210에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Forerunner 210 19 페이지. Gps-enabled sports watch
Garmin Forerunner 210에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (13 페이지), 중요 안전 지침 매뉴얼 (36 페이지), 사용 설명서 (25 페이지), 적합성 선언 (6 페이지), 빠른 시작 매뉴얼 (13 페이지), 소유자 매뉴얼 (18 페이지)
![Garmin Forerunner 210 설치 지침 매뉴얼](/uploads/products/server2/2330976/2330976.png)
Tools Needed
• Drill
◦ Bail mount: drill bits appropriate for the surface and hardware
◦ Flush mount: 14 mm (
bit (with no nut plate)
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (recommended)
Mounting Considerations
This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The
temperature range for this device is listed in the product specifications. Extended exposure to temperatures
exceeding the specified temperature range, in storage or operating conditions, may cause device failure.
Extreme-temperature-induced damage and related consequences are not covered by the warranty.
When selecting a mounting location, you should observe these considerations.
• The location should provide optimal viewing as you operate your boat.
• The location should allow for easy access to all device interfaces, such as the keypad, touchscreen, and card
reader, if applicable.
• The location must be strong enough to support the weight of the device and protect it from excessive
vibration or shock.
• To avoid interference with a magnetic compass, the device should not be installed closer to a compass than
the compass-safe distance value listed in the product specifications.
• The location must allow room for the routing and connection of all cables.
• The location must not be a flat, horizontal surface. The location should be in a vertical angle.
The location and viewing angle should be tested before you install the device. High viewing angles from
above and below the display may result in a poor image.
2
9
1
/
in.), 6 mm (
/
in.) and 3.6 mm (
16
4
9
/
in.) (with nut plate), or 3.2 mm (
64
NOTICE
1
/
in.) drill
8