Garmin Forerunner 210 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Garmin Forerunner 210에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Forerunner 210 19 페이지. Gps-enabled sports watch
Garmin Forerunner 210에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (13 페이지), 중요 안전 지침 매뉴얼 (36 페이지), 사용 설명서 (25 페이지), 적합성 선언 (6 페이지), 빠른 시작 매뉴얼 (13 페이지), 소유자 매뉴얼 (18 페이지)

Connecting the Wiring Harness to Power

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or

product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product

specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product

warranty.

1 Route the wiring harness to the power source and to the device.

2 Connect the red wire to the positive (+) battery terminal, and connect the black wire to the negative (-) battery

terminal.

3 If necessary, install the locking ring and O-ring on the end of the wiring harness.

4 Insert the cable into the POWER connector on the back of the device, pushing firmly.

5 Turn the locking ring clockwise to attach the cable to the device.

Additional Grounding Consideration

This device should not need additional chassis grounding in most installation situations. If you experience

interference, the grounding screw on the housing can be used to connect the device to the water ground of the

boat to help avoid the interference.

Garmin Marine Network Considerations

A Garmin Marine Network PoE Isolation Coupler (010-10580-10) must be used when connecting any third-party

device, such as a FLIR

camera, to a Garmin Marine Network. Connecting a Power over Ethernet (PoE) device

directly to a Garmin Marine Network chartplotter damages the Garmin chartplotter and may damage the PoE

device. Connecting any third-party device directly to a Garmin Marine Network chartplotter will cause abnormal

behavior on the Garmin devices, including the devices not properly turning off or the software becoming

inoperable.

This device can connect to additional Garmin Marine Network devices to share data such as radar, sonar,

and detailed mapping. When connecting Garmin Marine Network devices to this device, observe these

considerations.

• All devices connected to the Garmin Marine Network must be connected to the same ground. If multiple

power sources are used for Garmin Marine Network devices, you must tie all ground connections from all

power supplies together using a low resistance connection or tie them to a common ground bus bar, if

available.

• A Garmin Marine Network cable must be used for all Garmin Marine Network connections.

◦ Third-party CAT5 cable and RJ45 connectors must not be used for Garmin Marine Network connections.

◦ Additional Garmin Marine Network cables and connectors are available from your Garmin dealer.

• The ETHERNET ports on the device each act as a network switch. Any compatible device can be connected

to any ETHERNET port to share data with all devices on the boat connected by a Garmin Marine Network

cable.

WARNING

NOTICE