Garmin G300 for Cessna SkyCatcher 사용자 설명서 - 페이지 10
{카테고리_이름} Garmin G300 for Cessna SkyCatcher에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin G300 for Cessna SkyCatcher 22 페이지. Vhf comm
Garmin G300 for Cessna SkyCatcher에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (8 페이지)
페이지 인쇄
Detailed Operation
Getting Started
Selecting Frequencies
Volume, Power, and Squelch Control
119.80
119.80
Frequency selection with Large and Small knobs
119.80
s121.50
121.50
s119.80
Toggle Standby and Active frequencies with the
Flip/Flop button
4
This section introduces the basic operating details of the SL40 VHF Communications Transceiver.
Power On/Off
Turn the Power/Volume control clockwise past the OFF detent. The SL40 may be installed to be
powered from the avionics panel so the on/off control will be disabled.
Volume
Turn the Power/Volume knob clockwise to increase the volume level and counterclockwise to de-
crease volume.
Squelch
Pull the Power/Volume knob out to disable automatic squelch.
Selecting Frequencies
New frequencies are first selected as a Standby frequency and then toggled to the Active side when
desired. While viewing the frequency display, use the Large and Small knobs on the right side of the
SL40 to select the desired frequency.
1. Turn the Large, outer knob to change the values in 1 MHz increments. The MHz selection range is
between 118 and 136 in 1 MHz steps.
2. Turn the Small, inner knob to change the values in 25 kHz increments. The kHz selection range is
between 000 and 975 kHz in 25 kHz steps. Note that only two digits are displayed to the right of the
decimal point.
Turn the Large and Small knobs clockwise to increase and counterclockwise to decrease the fre-
quency values. Standby frequency selection is not inhibited during transmit.
Press the Flip/Flop button to toggle the Standby frequency to the Active frequency.
Detailed Operation