Garmin G300 for Cessna SkyCatcher 사용자 설명서 - 페이지 12
{카테고리_이름} Garmin G300 for Cessna SkyCatcher에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin G300 for Cessna SkyCatcher 22 페이지. Vhf comm
Garmin G300 for Cessna SkyCatcher에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (8 페이지)
페이지 인쇄
Detailed Operation
Getting Started
Auto Stack, User, & Weather Frequencies
119.10 LST121.80
Viewing the Auto Stack List
119.10 MEM121.80
119.10 MEM124.55
Viewing User Stored Frequencies
119.10 WTH162.40
Viewing Weather Frequencies
162.400 MHz
162.425 MHz
162.450 MHz
162.475 MHz
162.500 MHz
162.525 MHz
162.550 MHz
Weather Frequencies (where available)
6
Auto Stack List (LST)
The SL40 keeps track of the last eight Active frequencies and stores them in a stack. Duplicate fre-
quencies are not stored.
1. Press RCL and then turn the Large, outer knob to display the Auto Stack List (LST).
2. Then, turn the Small, inner knob to view the stored frequencies. Frequencies are shown in the order of
use.
User Stored Frequencies (MEM)
When you press the MEM button the Standby frequency is stored in User memory. The SL40 stores
the last eight frequencies selected by the user. After eight User frequencies are stored, you will be prompt-
ed that the stack is full (mem full). You may then remove or replace the frequency, or abort the process.
Duplicate frequencies are not stored.
1. Press RCL and then turn the Large, outer knob to reach the User frequencies.
2. Turn the Small, inner knob to view the User stored frequencies in numeric order.
Weather (WTH)
The standard weather channels are stored in the memory of the SL40. You cannot transmit on a
weather channel frequency. Weather information service is not available in all countries. A small "x" to
the right of the Active frequency indicates that transmitting is not permitted.
1. Press RCL and then turn the Large, outer knob to display the weather (WTH) channel memory.
2. Then, turn the Small, inner knob to view the available weather channels.
Aborting a Frequency Recall
You may abort the recall of a frequency so the current Standby frequency will remain in place.
1. Press RCL. While viewing one of the frequency types, press MEM. If you are viewing a REM, LST, or
WTH frequency type, the display will read "Abort RCL." If you are viewing a User (MEM) frequency type,
turn the Large knob to "Abort RCL."
2. Press MEM again to abort the recall and retain the current Standby frequency.