Garmin GTX 345 운영자 매뉴얼 - 페이지 25
{카테고리_이름} Garmin GTX 345에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 345 28 페이지. Enstrom 480b ads-b transponder
Garmin GTX 345에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (34 페이지), 운영자 매뉴얼 (28 페이지)
페이지 인쇄
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
6. The following system limitations are applicable when
there is no heading source (EFIS, EHSI, HSI, or CDI)
interfaced to the GTX:
a. The traffic page is oriented to rotorcraft TRACK, and
may or may not align with the rotorcraft heading.
b. The traffic display will not show ADS-B traffic when
groundspeed is less than 15 kts. Aural traffic alerts
will issue, appropriately. If interfaced with TAS:
7-3. Operation
A view of the front panel is shown in Figure 7-3. The control
keys and functions are briefly explained in Table 7-1.
1. Position the AVI MSTR switch to ON to apply system
power, if not already switched on.
a. Press either the ON, SBY, or ALT keys to turn on
b. After power-on, a start-up page is displayed while
Report No. 28-AC-078
This electronic document is not linked to a subscription for revision control or distribution. Refer to the Optional Equipment
Supplement Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
ENSTROM 480B RFM SUPPLEMENT
TAS traffic targets will continuously display at all
speeds.
If in excess of 15 knots in backward or sideward
flight, TAS and ADS-B targets may not correlate.
Two targets may appear on the display for each
actual target being received over both ADS-B and
TAS.
Figure 7-3. GTX 345 Front Panel
the unit.
the system performs a self-test. If the unit detects
an
internal
"TRANSPONDER FAILED".
level of this Rotorcraft Flight Manual Supplement.
failure,
the
7-5
screen
displays
Dec 3/18