Garmin VHF 315 Series 소유자 매뉴얼 - 페이지 19
{카테고리_이름} Garmin VHF 315 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin VHF 315 Series 32 페이지.
Garmin VHF 315 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (15 페이지)
페이지 인쇄
Receiving Position Requests
You can configure the radio to reply automatically to incoming position requests, or prompt you to review and
approve the incoming requests before replying
When you receive a position request with automatic position replies enabled, SENDING ACKNOWLEDGE
appears on the screen, and the radio sends your position automatically. After the position successfully
transmits, POSITION SENT appears on the screen.
When you receive a position request with automatic position replies disabled, POS. REQUEST appears on the
screen.
When you receive a position request with automatic position replies disabled, select OK, and select an
option:
• To reply to the position request with your current position, select OK.
If GPS-position or manual-position data is available, the radio transmits your position to the other vessel.
• To ignore the position request, press CLEAR.
Receiving Position Calls
When you receive a position call, POS. SEND and the position data appear on the screen.
Select OK.
The radio saves the position report in the call log.
Receiving Group Calls
When you receive a group call, GROUP appears on the screen, and the radio prompts you to change to the
requested channel. If the channel requested is invalid, INVALID CH REQUEST appears on the screen.
1 Select OK.
2 Turn the ENTER dial to select the requested channel.
3 Select OK.
Position Tracking
When you enable position tracking, the radio uses interval-based position requests to track up to three vessels.
Your radio transmits received position data over the NMEA network, and you can track the vessels using your
Garmin chartplotter
(Configuring DSC NMEA Transmissions, page
Selecting Vessels and Activating Position Tracking
Before you can use position tracking, you must have at least one vessel saved in the directory
page
18).
1 Select DSC > POS. TRACKING > ADD ENTRY.
2 Select the vessels you want to track.
You can track the position of up to three vessels at one time. If you select a fourth vessel, the radio sounds
an error tone, and you must remove a vessel before you can add a new one.
3 Select BEGIN TRACKING.
appears on the screen when the radio tracks vessels.
Digital Selective Calling
(Sending Automatic Replies, page
21).
19).
(Directory,
15