Fujitsu ABT24AG 운영 매뉴얼 - 페이지 11
{카테고리_이름} Fujitsu ABT24AG에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABT24AG 17 페이지. Floor console/under ceiling dual type
Fujitsu ABT24AG에 대해서도 마찬가지입니다: 운영 매뉴얼 (17 페이지), 운영 매뉴얼 (17 페이지)
페이지 인쇄
ADJUSTING THE DIRECTION OF AIR CIRCULATION
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
Vertical (up-down) direction of airflow is adjusted by pressing the remote control unit's AIR FLOW DIRECTION VERTICAL SET
button. Horizontal (right-left) direction of airflow is adjusted by pressing the remote control unit's AIR FLOW DIRECTION
HORIZONTAL SET button.
Vertical Air Direction Adjustment
Press the AIR FLOW DIRECTION VERTICAL SET button .
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air flow Direction Setting:
1,2,3,4
:
During Cooling/Dry Modes
5,6,7
: * During Heating mode
The remote control unit's display does
not change.
G Use the air direction adjustments within the ranges shown above.
G The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry mode : Horizontal flow 1
* During Heating mode
G During AUTO mode operation, for the first minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this pe-
riod.
Horizontal Air Direction Adjustment
Press the AIR FLOW DIRECTION HORIZONTAL SET button .
Each time the button is pressed, the air direction range will change as follows:
1
The remote control unit's display does
not change.
G Use the air direction adjustments within the ranges shown above.
Fig. 9
2
3
4
5
Fig. 8
: Downward flow 7
2
3
4
5
RIGHT/LEFT air direction louvers
6
7
DANGER!
Never place fingers or foreign objects inside
the outlet ports, since the internal fan oper-
ates at high speed and could cause personal
injury.
G Always use the remote control unit's
AIR FLOW DIRECTION button to adjust
the UP/DOWN air direction flaps or
RIGHT/LEFT air direction louvers. At-
tempting to move them manually
could result in improper operation; in
this case, stop operation and restart.
The louvers should begin to operate
properly again.
G During use of the Cooling and Dry
modes, do not set the UP/DOWN air
direction flaps in the Heating range (5
to 7) for long periods of time, since
water vapor may condense near the
outlet louvers and drops of water may
drip from the air conditioner.
G When used in a room with infants, chil-
dren, elderly or sick persons, the air
direction and room temperature
should be considered carefully when
making settings.
SET
SWING
SET
SWING
TIME
TEST
ENAGY
ADJUST
RUN ACL
SAVE
Example: When set to vertical air direc-
tion
SET
SWING
SET
SWING
TIME
TEST
ENERGY
ADJUST
RUN ACL
SAVE
Example: When set to horizontal air di-
rection
11