Fujitsu ABYA12-24LBTH 설치 매뉴얼 - 페이지 20
{카테고리_이름} Fujitsu ABYA12-24LBTH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABYA12-24LBTH 21 페이지. Vrf system indoor unit floor / ceiling type
페이지 인쇄
(2) Join the cover plates (right) and mount with screws.
] 1
8.3. Mount the cover plate (Left)
(1) Join the cover plates (left) and mount with screws.
Tapping screw (ø4 × 10)
(Accessories)
8.4. Mount the intake grille
(1) Cut the right side of the intake grille. This is only when the
pipe exits from the right side.
(2) Insert the hinges on the bottom of the intake grille into the
holes in the base assembly. Then mount the arms to the
3 areas on the top of the intake grille.
En-20
×
Tapping screw (ø4
10)
(Accessories)
Cover plate (Left)
(Accessories)
9. TEST OPERATION
] 1
9.1. Test operation using PCB (Outdoor
unit)
• Refer to the Installation Manual for the outdoor unit if the
PCB for the outdoor unit is to be used for the test operation.
] 1
9.2. Test operation using remote controller
• Refer to the Installation Manual for the remote controller to
perform the test operation using the remote controller.
• When the air conditioner is being test run, the OPERATION
and TIMER indicator lamps fl ash slowly at the same time.
10. CHECK LIST
Pay special attention to the check items below when
] 1
installing the indoor unit(s). After installation is complete, be
sure to check the following check items again.
Check items
Has the indoor unit
been installed correctly?
Has there been a
check for gas leaks
(refrigerant pipes)?
Has heat insulation
work been completed?
Does water drain easily
from the indoor units?
Is the voltage of the
power source the same
as that indicated on the
label on the indoor unit?
Are the wires and
pipes all connected
completely?
Is the indoor unit
grounded?
Is the connection cable
the specifi ed thickness?
Are the inlets and outlets
free of any obstacles?
Does start and stop air
conditioner operation
by remote controller
or external device?
After installation is
completed, has the
proper operation
and handling been
explained to the user?
If not performed
correctly
Vibration, noise,
indoor unit may drop
No cooling, No heating
Water leakage
Water leakage
No operation, heat
or burn damage
No operation, heat
or burn damage
Short circuit
No operation, heat
or burn damage
No cooling, No heating
No operation
Check
box