a-gear P1004T EPON 하드웨어 설치 매뉴얼 - 페이지 10
{카테고리_이름} a-gear P1004T EPON에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. a-gear P1004T EPON 13 페이지. Optical network unit
페이지 인쇄A-GEAR World Wide Manufacturing
3.3.
Co nn e c t i ng po r t s
3.3. 1.
G EP O N S FF O pt i c a l Po r t
A-GEAR P1004T EPON provides 1 GEPON SFF port. Indicator lamps corresponding to this
port are PON and LOSS. During use, connect SC optical fibre to the port, and then to optical
splitter and then from optical splitter to OLT equipment.
3.3. 2.
E t he r n e t El ec t r ic a l Po r t
A-GEAR P1004T EPON provides 4 10/100Base-Tx ports. During use, connect UTP port of
EPON access device to other Ethernet terminal equipment through network cable (direct
connection or cross). See following table for No., sequence and arrangement of UTP port
pins.
As all of the four 10/100Base-Tx ports of A-GEAR P1004T EPON support MDI/MDIX self-
recognition function of the cable, when connecting A-GEAR P1004T EPON with other
Ethernet terminals, either Class V direct network cable or Class V cross network cable may be
used, which facilitates the selection of cable.
Pi n No.
1
Positive phase terminal of data transfer
2
Reverse phase terminal of data transfer
3
Positive phase terminal of data receipt
4
Positive phase terminal of data transfer
5
Reverse phase terminal of data transfer
6
Reverse phase terminal of data receipt
7
Positive phase terminal of data receipt
8
Reverse phase terminal of data receipt
As supporting self-recognition function of the direct/cross network cable, either Class
V direct network cable or Class V cross network cable may be used to connect
A-GEAR P1004T EPON with other Ethernet equipment.
A-GEAR P1004T EPON Optical Network Unit (ONU)
Figure 3-1. RJ-45 Connector.
P in n am e
Table 3-3. Table of Definition of 1000MB RJ45 Pins
E ng lis h nam e
Re m a rks
TXD1 +
TXD1-
RXD1 +
TXD2+
TXD2-
RXD1-
RXD2+
RXD1-
datasheet
output
output
input
output
output
input
input
input
a-gear.net
Раge 10 of 13