AEG OKO FAVORIT 40660 i 사용자 지침 - 페이지 35
{카테고리_이름} AEG OKO FAVORIT 40660 i에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO FAVORIT 40660 i 48 페이지. Aeg dishwasher
AEG OKO FAVORIT 40660 i에 대해서도 마찬가지입니다: 사용자 정보 (44 페이지), 사용자 지침 (40 페이지), 사용자 지침 (44 페이지), 사용자 지침 (44 페이지)
페이지 인쇄
Connecting the Dishwasher
Water Connection
The dishwasher is fitted with safety devices that prevent the wash
water returning into the drinking water system and comply with the
applicable plumbing regulations.
• The dishwasher can be connected to cold and hot water supplies up
to max. 60 °C.
• The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure:
1 bar (=10 N/cm
Highest permitted water pressure:
10 bar (=100 N/cm
Connect the inlet hose
The water inlet hose must not be kinked, crushed or entangled when it
1
is being connected up.
Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet
0
hose to a tap with an external thread (¾ inch). Tighten the threaded
hose fitting hand tight only.
• In order that access to the tap in the kitchen is not limited by the use
3
of the dishwasher, we recommend the installation of an additional
tap, or fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, VDE
approved complete hose sets are to be used. These are available from
your local Service Force Centre.
2
=100 kPa)
2
=1 MPa)
Installation and Connection Instructions
Consult your installer if the water pres-
sure is less than 1 bar.
In the case of a water pressure greater
than 10 bar, a pressure reduction valve
must be used (available from your
dealer).
35