AEG OKO FAVORIT 40660 i 사용자 지침 - 페이지 36

{카테고리_이름} AEG OKO FAVORIT 40660 i에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO FAVORIT 40660 i 48 페이지. Aeg dishwasher
AEG OKO FAVORIT 40660 i에 대해서도 마찬가지입니다: 사용자 정보 (44 페이지), 사용자 지침 (40 페이지), 사용자 지침 (44 페이지), 사용자 지침 (44 페이지)

페이지 인쇄
AEG OKO FAVORIT 40660 i 사용자 지침
Installation and Connection Instructions
The following section is only applicable to dishwashers that have a
3
safety valve on the threaded hose fitting for the tap:

Water inlet hose with safety valve

After connecting the double-walled water inlet hose, the safety valve is
next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water and the
draining pump in the dishwasher is switched on.
Please take care when installing the water inlet hose:
1
– The distance between the bottom
edge of the safety value and the
floor on which the dishwasher is
standing must be at least 30 cm:
– The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety valve
in water.
– If the water inlet hose or the safety
valve is damaged, remove the
mains plug immediately.
– A water inlet hose with safety valve
must only be replaced by a
specialist or Customer Services.
– Place the water inlet hose in such a way that it is never higher than
the bottom edge of the safety valve.
36