Brother MFC-J825DW 빠른 설정 매뉴얼 - 페이지 22

{카테고리_이름} Brother MFC-J825DW에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J825DW 42 페이지. Quick setup guide - spanish
Brother MFC-J825DW에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 매뉴얼 (21 페이지), 제품 안전 매뉴얼 (17 페이지), 웹 연결 매뉴얼 (22 페이지), 빠른 설정 매뉴얼 (45 페이지), 안전 매뉴얼 (17 페이지), 문제 해결 매뉴얼 (6 페이지), (스페인어) 매뉴얼 (21 페이지), (스페인어) 매뉴얼 (16 페이지), (영어) 빠른 구성 가이드 (44 페이지)

Wired Network

For wired network interface users

Before you install

Make sure your machine is connected to the power

and your Macintosh is ON. You must be logged on

with Administrator rights.

Note

• For Mac OS X 10.4.0 to 10.4.10 users, upgrade

to Mac OS X 10.4.11 - 10.6.x.

• If you have previously set up your machine for

a wireless network and then want to set it up on

a wired network, you should check that the

machine's Network I/F is set to

Wired LAN. The wireless network interface

will become inactive with this setting.

On your machine, press Menu.

Press Network.

Press Network I/F.

Press Wired LAN.

Press Stop/Exit.

Connect the network

cable

Using both hands, use the plastic tabs on both

sides of the machine to lift the scanner cover

until it locks securely into the open position.

(Mac OS X 10.4.11, 10.5.x, 10.6.x)

You will find the Ethernet port marked with a

symbol inside the machine on the left as

shown below. Remove the protective cap and

connect the network cable to the Ethernet port.

Carefully guide the network cable into the cable

channel and out the back of the machine.

Connect the cable to your network.

IMPORTANT

Make sure that the cable does not restrict the

cover from closing, or an error may occur.

Note

If both the USB and the LAN cables are being

used, guide both cables through the cable

channel with one on top of the other.

Macintosh

USB