AEG 35610C 사용 설명서 - 페이지 25

{카테고리_이름} AEG 35610C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 35610C 28 페이지. Gas hob
AEG 35610C에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (24 페이지), 작동 및 설치 지침 (24 페이지)

페이지 인쇄

Commissioning

When the hob has been fully installed it will be necessary to check the minimum flame setting. To

do this, follow the procedure below.

1) Turn the gas tap to the MAX position and ignite.

2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX

several times. If the flame is unstable or is extinguished follow the procedure below.

Procedure:

1) Re-ignite the burner and set to MIN.

2) Remove the control knob.

3) To adjust, use a thin bladed

screwdriver and turn the adjustment

screw until the flame is steady and

does not extinguish, when the knob

is turned from MIN to MAX. Repeat

this procedure for all burners.

Pressure Testing

1) Remove left hand pan support and front left burner cap and crown.

2) Fit manometer tube over the injector.

3) Turn on the burner gas supply and ignite another burner supply.

The pressure reading should be nominally 20mbar and must be between 17 mbar

and 25mbar.

4) Turn off the burner supplies.

Minimum adjustment screw