AEG 35941G 작동 및 설치 지침 - 페이지 21

{카테고리_이름} AEG 35941G에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 35941G 27 페이지. Gas hob
AEG 35941G에 대해서도 마찬가지입니다: 작동 및 설치 지침 (26 페이지), 운영 및 설치 매뉴얼 (26 페이지), 사용 설명서 (20 페이지), 작동 및 설치 지침 (26 페이지), 작동 및 설치 지침 (26 페이지)

Permanent Connection

In the case of a permanent connection, it is necessary that you install

a double pole switch between the hob and the electricity supply

(mains), with a minimum gap of 3 mm. between the switch contacts

and of a type suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth cable at any

point.

Ensure that the hob supply cord does not come into contact with

surfaces with temperatures higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block

is of type "Y". This means that its replacement requires the specific

equipment of a technician.

In this case, only cable type H05RR-F must be used. The cable section

must be suitable to the voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm. longer than

the phase wires.

1. TAPS IGNITOR SWITCHES

2. IGNITOR UNIT

Electrical connections

220

240