AEG 600 M 운영 및 설치 매뉴얼 - 페이지 13

{카테고리_이름} AEG 600 M에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 600 M 18 페이지. Ceramic glass hob
AEG 600 M에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (16 페이지)

AEG 600 M 운영 및 설치 매뉴얼
1

Safety Instructions for the Installer

• This hob must be installed by qualified personnel, according to the
manufacturer's instructions and to the relevant country standards.
• In respect of fire protection, this appliance corresponds to type Y (IEC
335-2-6). Only this type of appliance may be installed with a high
cupboard or wall on one side.
• It is not permitted to fit drawers below the cooking surface.
• Protection against electric shock must be provided by the installa-
tion.
• The kitchen unit in which the appliance is fitted must satisfy the
requirements of DIN 68930 in respect of stability.
• Built-in ovens and cooking surfaces are fitted with special connector
systems. They may only be combined with appliances with a matching
system.
• All cut surfaces are to be sealed with a suitable sealant for protection
against moisture.
• On tiled work surfaces, the joints in the area where the hob sits on
the surface must be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the snap action springs
must be bonded in place.
• Ensure that the seal is correctly seated in the frame and that it is
seated against the work surface without leaving any gaps. Additional
silicon sealant must not be applied, this will make removal more diffi-
cult in the event of the need for service.
• To remove the hob, it must be pressed out from below.

Electrical connection

• Connect the wiring harness plugs with the respective sockets of the
same colour of the built-in oven or switch box.
Installation Instructions
27