A-I-R ATOS VR 운영 매뉴얼 - 페이지 6

{카테고리_이름} A-I-R ATOS VR에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A-I-R ATOS VR 17 페이지.

12. Slide the tube in aligning the key and the key slot until the tube bottoms out (pictured above). The

carbon leading edge shell packs along the front edge. You'll be able to find it just outside the end of the

D-cell as shown, slide it out along the aluminum extension tube. Now pull the sail outward so that you can

bring the last fish cam around the tube end leaving the tube extending from the end of the sail (shown

below).

13. Depress the two pins on the Wingtip tube and slide it into the extension tube until they pop and the

wingtip is solidly engaged. Slide the carbon leading edge extension out until it overlays the white wingtip.

14. You are now prepared to engage the tip wand and tighten the sail to the wingtip.

TIP: It is important

at this point to have the sail well aligned with itself. Tear the Velcro apart going back 24+ inches.

Align the very tips of the sail - top to bottom and then match and seal the Velcro (leave open as

much as shown).

Grasp the tip lever in your left hand and the tip wand rope in your right (there are

three ropes - one at each end of the tip lever and one on the end of the tip wand). Pull the lever toward

you and the push the rope inside the sail to engage the wand tip to the lever. Observe how the left hand

stays below the wing tip and in line with the plane of the sail.

Be sure you are not pushing toward the

D-cell - you will be working against yourself and will find this step and especially the next, very

difficult.