Brother Work Smart MFC-J870dw 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Brother Work Smart MFC-J870dw에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Work Smart MFC-J870dw 45 페이지. Work smart series inkjet all-in-one
Brother Work Smart MFC-J870dw에 대해서도 마찬가지입니다: 에어 프린트 매뉴얼 (12 페이지), 사양 (2 페이지), 기본 사용 설명서 (14 페이지)

페이지 인쇄

1. Connect the Usb Cable

Take care to match the sticker colour a with

the cartridge colour b as shown in the diagram

below.

Install each ink cartridge in the direction of the

arrow on the label.

Gently push the back of the ink cartridge

marked "PUSH" until the cartridge lever lifts.

After all the ink cartridges are installed, close

the ink cartridge cover.

NOTE

The machine will prepare the ink tube system for

printing. This process will take approximately four

minutes. Do not turn off the machine. We

recommend you perform the next step while

waiting.

Load plain A4 paper

Pull the paper tray a completely out of the

machine.

Open the output paper tray cover a.

Gently press and slide the paper width

guides a and then the paper length guide b to

fit the paper size.

Make sure that the triangular marks c on the

paper width guides a and paper length

guide b line up with the mark for the paper size

you are using.