AEG 65402 G 지침 책자 - 페이지 7

{카테고리_이름} AEG 65402 G에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 65402 G 32 페이지. Aeg hobs brochure
AEG 65402 G에 대해서도 마찬가지입니다: 브로셔 및 사양 (12 페이지)

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

To light a burner:

turn the relevant knob anticlockwise to maximum

position (

Upon ignition, keep the knob pushed down

about 5 seconds. This will allow the

"thermocouple" (Fig. 1 - letter D) to be heated and

the safety device to be switched off, otherwise

the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control

knob to zero, and try again.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1 - letter A) and

"crown" (Fig. 1 - letter B) are in the correct position.

Only in Mod. 65852: Each control knob is

equipped with a pilot light which gradually

lights up according to the heat level that you

select with the control knob.

When switching on the mains, after installation

or a power cut, it is quite normal for the spark

generator to be activated automatically.

In the absence of electricity, ignition can occur

without the electrical device; in this case,

approach the burner with a flame, push the

relevant knob down and turn it anti-clockwise

until it reaches the "maximum" position.

If the control knobs become difficult to turn,

please contact your local Service Force Centre.

Triple Crown Burner

(Mod. 65852 G)

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1