AEG 65402 G Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня AEG 65402 G. AEG 65402 G 32 сторінки. Aeg hobs brochure
Також для AEG 65402 G: Брошура та технічні характеристики (12 сторінок)

Друкувати сторінку

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

To light a burner:

turn the relevant knob anticlockwise to maximum

position (

Upon ignition, keep the knob pushed down

about 5 seconds. This will allow the

"thermocouple" (Fig. 1 - letter D) to be heated and

the safety device to be switched off, otherwise

the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control

knob to zero, and try again.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1 - letter A) and

"crown" (Fig. 1 - letter B) are in the correct position.

Only in Mod. 65852: Each control knob is

equipped with a pilot light which gradually

lights up according to the heat level that you

select with the control knob.

When switching on the mains, after installation

or a power cut, it is quite normal for the spark

generator to be activated automatically.

In the absence of electricity, ignition can occur

without the electrical device; in this case,

approach the burner with a flame, push the

relevant knob down and turn it anti-clockwise

until it reaches the "maximum" position.

If the control knobs become difficult to turn,

please contact your local Service Force Centre.

Triple Crown Burner

(Mod. 65852 G)

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1