Brother GTX 사용자 참조 설명서 - 페이지 13

{카테고리_이름} Brother GTX에 대한 사용자 참조 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother GTX 16 페이지. Step by step photo instructions
Brother GTX에 대해서도 마찬가지입니다: 포장 풀기 매뉴얼 (17 페이지), 스탠드 조립 (5 페이지)

페이지 인쇄

1. Maintenance Parts Exchange

WHEN YOU'RE NOT USING THE PRINTER FOR A LONG PERIOD OF TIME

Depending on the length of time you intend on not using the printer will determine which

run down procedure to follow:

NEVER turn the printer OFF, otherwise, the printer may be damaged.

UP TO 2 WEEKS

• Clean the Nozzle Guard, Wiper Blade and Exhaust Cap

• Empty the waste ink in the Waste Ink tank

• Check the amount of Cleaning Solution in the Cleaning Solution tank is filled to

the maximum level

• Agitate the white ink if a white ink cartridge stirring message is displayed on the

operation panel screen

• Print out a Nozzle Check pattern

FOR MORE THAN 2 WEEKS (Use White ink Pause mode)

• Clean the Nozzle Guard, Wiper Blade and Exhaust Cap

• Empty the waste ink in the waste ink tank

• Check that the amount of Cleaning Solution in the Cleaning Solution tank is filled to the

maximum level

• From the menu, select [Maintenance] > [White Ink Pause Mode] > [Enable] Then Press

• Remove the White ink cartridges and replace both White Ink Pouches with Maintenance

Pouches [GCX-4S70]. Insert the White Ink Cartridges back into the printer. Then Press

Note: When you need to print with white ink again,

• Empty the waste ink in the waste ink tank

• From the menu, select [Maintenance] > [White Ink Pause Mode] > [Disable]. Then Press

• Remove the White ink cartridges and replace both Maintenance Pouches with brand new White

Ink Pouches. Insert the White Ink Cartridges back into the printer. Then Press

CMYK & White inks, Cleaning Solution, Maintenance Solution &

Pre-Treatment Solution should be stored at a temperature range

between 0° and 40°.

Do not store consumables outside this temperature range

HOW TO EXTRACT A LOG FILE FROM THE PRINTER

Switch on the printer and insert a USB stick

Go to the menu:

Maintenance

Log copy to USB

you will need to Disable White Ink Pause Mode

INK & SOLUTIONS STORAGE

STORAGE

TEMPERATURE

MIN

MAX