Brother GTX 사용자 참조 설명서 - 페이지 11

{카테고리_이름} Brother GTX에 대한 사용자 참조 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother GTX 16 페이지. Step by step photo instructions
Brother GTX에 대해서도 마찬가지입니다: 포장 풀기 매뉴얼 (17 페이지), 스탠드 조립 (5 페이지)

페이지 인쇄

1. Maintenance Parts Exchange

MAINTENANCE PARTS CLEANING & REPLACING PROCEDURES

WARNING

Always use this menu to perform cleanings or replace parts:

Maintenance

WIPER CLEANER REPLACEMENT

Simply remove the old Wiper Cleaner by lifting it up. Replace with a new one.

FLUSHING FOAM REPLACEMENT

Lift up the flushing receivers

and place them on a waste

cloth to avoid dripping ink.

FAN FILTER REPLACEMENT

MAINTENANCE PARTS EXCHANGE

In case of Warning/Error messages please follow the

ERROR

following procedures:

Maintenance Part Clean/Replace

Remove Flushing Foams and clean the

holes of the 2 receivers.

MESH

AIR FLOW

FINE

COARSE

and follow instructions on the display

Watch the Video: Replace the GTX Wiper Cleaner

Watch the Video: Flushing Foams Replacement

Check and clean where the retainer sits

on the maintenance unit to ensure ink is

not blocking drainage.

Install new foams and return the

receivers to their original location.

Watch a Video: Fan Filter Replacement

Remove the 2 Fan Filter holders from the

top rear of the printer.

Remove the old filters and install new Fan

Filters in two black Fan Filter holders.

Note: Face the coarse mesh side of the

Fan filter towards the inside of the printer

and the fine mesh side towards the

outside of the printer