AEG 40809 사용자 지침 - 페이지 34
{카테고리_이름} AEG 40809에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 40809 40 페이지.
페이지 인쇄
Installation and connection instructions
Position
In order to install your washing machine, you will need:
An electricity power supply (see electrical connection).
A water inlet with a 20 x 27 mm connection.
A water drain with a minimum height of 70 cm.
A ventilated room.
Put your washing machine on a hard and flat floor.
Make sure that your washing machine does not touch the wall or any other
elements in the kitchen.
Warning: when your machine is installed on a floor with a carpet, make sure
that the carpet does not block any of the openings near the bottom of the
machine, since they are necessary for ventilation.
The tap, drainage installation and the power outlet must be close to the
machine pipes and the power supply cable.
Do not install the washing machine in a room subject to frost.
Leveling and moving the washing machine
Level the washing machine by screwing the leveling screws in or out.
Precise leveling will prevent vibrations, noise and movements of the machine
during operation.
After leveling, fix the leveling screws in position by tightening the rings
manually or using a screwdriver.
When you want to move your washing machine, lift it on its rollers by pulling
the lever at the bottom of the washing machine from the right towards the
left. Put the lever back into its initial position once you have put the machine
where you want it.
34