Brother RuggedJet RJ-2050 빠른 설정 매뉴얼 - 페이지 3
{카테고리_이름} Brother RuggedJet RJ-2050에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother RuggedJet RJ-2050 9 페이지. Rd rolls
Brother RuggedJet RJ-2050에 대해서도 마찬가지입니다: 제품 안전 매뉴얼 (16 페이지)
페이지 인쇄
Stopping Rechargeable Li-ion Battery Charging
To stop the battery charging, disconnect the AC adapter or car adapter from
the DC connector.
Notes on Using the Rechargeable Li-ion Battery
High density (dark) printing discharges the battery faster than low density
printing. You can adjust the print density setting in the Printer Setting Tool
(see the User's Guide).
The battery charging must take place between 5 and 35°C environments,
otherwise the battery will not be charged. If the charging stops because the
environment temperature is too low or too high, place your printer in an
environment with a temperature between 5 and 35°C and try charging
again.
If you use your printer when both the battery is installed and the
AC adapter or car adapter is connected, charging may stop even if the
battery is not fully charged.
Rechargeable Li-ion Battery Characteristics
To ensure the highest performance and longest life from the battery:
Do not use or store the battery in a location exposed to extreme high or low
temperatures as it may deteriorate more quickly.
Remove the battery when storing your printer for long periods of time.
Store batteries with less than a 50% charge in a cool dry place out of direct
sunlight.
Recharge the battery every six months if it is stored for long periods of
time.
It is normal and safe for the printer to become warm while charging.
Disconnect the charger and stop using the printer if it becomes hot to
the touch.
Setting the Paper or Label Roll
For RJ-2030/2050
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
1
Cover open lever
2.
Insert the media roll into the media roll compartment with the roll feeding
from the bottom as shown.
1
Print surface
(faces outwards on the roll)
3.
Close the media roll compartment by pressing down on the centre of the
cover until it locks into place.
1
1
For RJ-2140/2150
1.
Pull the cover open lever in the direction shown to open the media roll
compartment cover.
1
Cover open lever
2.
Open the roll guides by lifting up the roll guide adjustment lever and
pulling the roll guide outwards.
Insert the media roll into the media roll compartment with the roll feeding
from the bottom as shown.
1
2
2
1
Roll guide adjustment lever
2
Roll guide
3
Print surface
(faces outwards on the roll)
3.
While lifting up the roll guide adjustment lever, push in both roll guides
to the roll width. Insert the media roll so that it is positioned straight in
the media roll compartment.
4.
Close the media roll compartment by pressing down on the centre of the
cover until it locks into place.
Turning Your Printer On or Off
On: Press and hold the
(Power) button until the LCD turns on.
Off: Press and hold the
(Power) button until the message [System Off]
appears on the LCD.
IMPORTANT
Do NOT remove the battery until the LCD turns off.
1
3
1