Brother TJ-4420TN 설정 매뉴얼 - 페이지 3

{카테고리_이름} Brother TJ-4420TN에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother TJ-4420TN 4 페이지. Label peeler module

8. Fasten the remaining two Screws on the module's Front Cover as illustrated

(fastened by 0.74 N • m ± 0.10 N • m).

NOTE

To open the module's Front Cover, press the button on the side, as

illustrated.

Next, go to section B to install the Internal Liner Rewinder Module.

B. Install the Internal Liner Rewinder Module

1. Remove the four Screws as illustrated, and then remove the Rewind Spindle

Cover.

2. Thread the Power Cable from the PCB side and connect it to the Internal Liner

Rewind Module's power connector.

3. Use the four Screws supplied with the Internal Liner Rewinder Module to

secure it. (fastened by 1.03 N • m ± 0.15 N • m)

Next, go to section C to install the Media Guide Bar and Rear Label Guide

Module.