Fujitsu Lifebook C2010 바이오스 매뉴얼 - 페이지 6

{카테고리_이름} Fujitsu Lifebook C2010에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook C2010 31 페이지. Bios setup utility
Fujitsu Lifebook C2010에 대해서도 마찬가지입니다: 소프트웨어 설명서 (39 페이지)

페이지 인쇄
Fujitsu Lifebook C2010 바이오스 매뉴얼
L i f e B o o k C S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Primary Master [TOSHIBA MK3018GAP -(PM)]
Type:
Total Sectors:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
n
None
n
CD-ROM
n
Hard Disk
n
CHS Format (Cylinders, Heads, Sectors)
Cylinders:
A number
n
between
0 and 65,535
6
PhoenixBIOS Setup Utility
[Auto]
LBA Format
58605120
30006MB
[16 Sectors]
[Enabled]
[Multiword DMA 2]
[Disabled]
Select Item
-/Space
Select Menu
Enter
Figure 2. Primary Master Submenu
Default
Description
[Auto]
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected,
all of the following Set-up items do not appear. Select CD-ROM
if a CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive.
–—
This appears only when Hard Disk is selected. When Hard Disk is
selected, you can change the value. This field is incremented by
pressing the [Spacebar]) or by pressing [Shift] [+]. This field is
decremented by pressing the [-] key. You can also change the
field by typing in the number.
*Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
F9
Select
Sub-Menu
F10
Setup Defaults
Save and Exit