Brother P-TOUCH CUBE 사용자 설명서 - 페이지 16

{카테고리_이름} Brother P-TOUCH CUBE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother P-TOUCH CUBE 18 페이지. Tze tape
Brother P-TOUCH CUBE에 대해서도 마찬가지입니다: 사용자 설명서 (25 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (18 페이지), 사용자 설명서 (18 페이지)

페이지 인쇄

6. Pairing the Label Printer with Your Smartphone or Tablet

On your smartphone or tablet:

1. In Settings, access the Bluetooth option, and turn it ON.

2. When the list of discovered Bluetooth devices appears, tap PT-P300BT**** (where ****

is the last four digits of your label printer's serial number. Alternatively, you can find your

machine number on the sticker below the Power Button). The unit's serial number is

located where the TZe Tape Cassette is set inside the Cassette Cover.

3.If asked to enter a PIN Code, enter "0000".

NOTE

• Pairing instructions may differ slightly, depending on the smartphone or tablet you are

using.

• If the label printer is not discovered by your smartphone or tablet, the label printer may

already be connected to another device. If so, locate the smartphone or tablet that is paired

with the label printer, turn off Bluetooth on that device, and then power off the label printer

and power it back on.

• If the label printer is moved too far from your smartphone or tablet, it may disconnect. If this

happens, repeat these steps near the label printer to pair them again.

• If using a Smart Cover on your tablet, ensure that the cover remains open while you are

creating or printing labels. Closing the Smart Cover may interrupt data communication, and

your labels will not print.

7. Troubleshooting

Problem

I cannot turn on the label

printer.

A horizontal space runs

through the middle of the

printed label.

Check to see that the batteries are installed correctly, or that

the AC Adapter is securely connected.

Streaks or poor quality characters on printed labels generally

indicate that the Print Head is dirty. See the section

"Performing Routine Maintenance" for instructions on

cleaning the Print Head.

* Do not touch the Print Head with your bare hands.

Solution