Brother PT-E500 빠른 설정 매뉴얼 - 페이지 30

{카테고리_이름} Brother PT-E500에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-E500 46 페이지. Electronic labeling system
Brother PT-E500에 대해서도 마찬가지입니다: 운영자 매뉴얼 (6 페이지)

페이지 인쇄

GETTING STARTED

Feed Only

This function will advance the tape approximately 24.5mm resulting in a blank label sticking

out of the tape cassette. This action is recommended when using Fabric tapes, which should

be cut using scissors.

Press the Feed & Cut key.

"Feed & Cut?" will appear on the LCD display.

Using the

The message "Feeding Tape... Please Wait" appears while the tape is fed.

To exit or cancel this function press Esc.

LCD Contrast

You can change the contrast setting of the LCD display to one of five levels (+2, +1, 0, -1,

-2) to make the screen easier to read. The default setting is "0".

Press the Menu key, select "Adjustment" using the

or Enter key.

Select "LCD Contrast" using the

key.

Press the OK or Enter key.

• Press the Esc key to return to the previous step.

• Pressing the Space key on the contrast setting screen sets the contrast to the default value "0".

Backlight

You can change the backlight setting either to on or off.

The display is easier to see with the backlight on. The default setting is on.

Press the Menu key, and then select "Advanced" using the

Enter key.

Select "Backlight" using the

Select "On" or "Off" using the

• Power can be saved when the backlight is turned off.

• The backlight will automatically turn off after 10 seconds of inactivity, press any key to re-

enable it. During printing, the backlight is disabled. The backlight turns on during data

transmissions.

LCD Display

key to select the "Feed Only", and then press either OK or Enter key.

LCD Display

key, and then set the value using the

key, and press the OK or Enter key.

key, and then press the OK

key. Press OK or