Brother PT-E500 빠른 설정 매뉴얼 - 페이지 34

{카테고리_이름} Brother PT-E500에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-E500 46 페이지. Electronic labeling system
Brother PT-E500에 대해서도 마찬가지입니다: 운영자 매뉴얼 (6 페이지)

페이지 인쇄

EDITING A LABEL

PUNCH-DOWN BLOCK

Labels printed with this mode can be used to identify a type of electrical connection often

used in telephony. There are up to three lines for each block on a single label and you can

enter three lines for each block. In this mode, you can specify the following items.

• Module Width: 200 mm, 50 mm - 300 mm

• Block Type: 4 Pairs, 2 Pairs, 3 Pairs, 5 Pairs, Blank

• Sequence Type:

• Start Value: ---, 1 - 99999

• When "Blank" is selected in "Block Type", "Sequence Type" is set to None.

• When None is selected in "Sequence Type", "Start Value" shows "---" and you cannot set

a value. Horizontal or Backbone, however, allows you to set "Start Value" from 1 to 99999.

Heat Shrink Tube

When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen

will be displayed when any of the labeling application type keys is

pressed.

• Label length: Auto, 25 mm - 999 mm

However, the maximum printing length is 500 mm when using Heat Shrink Tube with a

width of 5.8 mm or 8.8 mm.

Text: Type in single or multiple lines of data

When using Heat Shrink Tube:

• You cannot print frames.

• Portions of some decorative characters may be cut off when a line is broken.

• The printed characters may be smaller than when using TZe tape.

Selecting a Labeling Application Type

(None),

(Horizontal),

(Backbone)