Brother PT-E500 빠른 설정 매뉴얼 - 페이지 33

{카테고리_이름} Brother PT-E500에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-E500 46 페이지. Electronic labeling system
Brother PT-E500에 대해서도 마찬가지입니다: 운영자 매뉴얼 (6 페이지)

페이지 인쇄

CABLE FLAG

Labels printed with this mode can be wrapped around a cable

or wire, and both ends of the label stick together to form a flag.

The text on flag labels is printed on both ends of the label,

leaving a blank space in the middle that wraps around the

cable. In this mode, you can specify the following items.

• Layout:

(The same text is printed on each

block.),

(Two different texts are printed on each block.)

• Flag Length: 30 mm, 10 mm - 200 mm

• Cable Diameter: 6.0 mm, 3.0 mm - 90.0 mm

• Orientation:

Horizontal

• You can enter up to two bar codes when

• We recommend using Flexible ID Tape for Cable Flag labels.

• Labels made with Flexible ID Tape are not designed for use as electrical insulation.

PATCH PANEL

Labels printed with this mode can be used to identify various

types of panels. In this mode, you can specify the following

items.

• Block Length: 15.0 mm, 5.0 mm - 300.0 mm

• # of Blocks: 4, 1 - 99

• Separator:

(Line),

(Bold),

• Orientation:

• Reverse: Off, On

• Advanced: Off, On

Adjust block length independently when "Advanced" is set to "On".

• No Margins: Off, On

Set the left and right label margins to zero.

"Advanced" and "No Margins" cannot be set to "On" at the same time.

(Horizontal),

Flag

Cable

Flag

length

circum-

length

ference

(Tic),

(Dash),

(Frame),

(Horizontal),

1A-B01 1A-B02 1A-B03

Block length

1. Flag at least 5 mm

(Vertical)

Vertical

Flag

Cable

length

circum-

ference

is selected in flag layout.

(None)

(Vertical)

Block length

Selecting a Labeling Application Type

Flag

length