Brother PT-E500 Panduan Pengaturan Cepat - Halaman 33
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pembuat label Brother PT-E500. Brother PT-E500 46 halaman. Electronic labeling system
Juga untuk Brother PT-E500: Panduan Operator (6 halaman)
Halaman Cetak
CABLE FLAG
Labels printed with this mode can be wrapped around a cable
or wire, and both ends of the label stick together to form a flag.
The text on flag labels is printed on both ends of the label,
leaving a blank space in the middle that wraps around the
cable. In this mode, you can specify the following items.
• Layout:
(The same text is printed on each
block.),
(Two different texts are printed on each block.)
• Flag Length: 30 mm, 10 mm - 200 mm
• Cable Diameter: 6.0 mm, 3.0 mm - 90.0 mm
• Orientation:
Horizontal
• You can enter up to two bar codes when
• We recommend using Flexible ID Tape for Cable Flag labels.
• Labels made with Flexible ID Tape are not designed for use as electrical insulation.
PATCH PANEL
Labels printed with this mode can be used to identify various
types of panels. In this mode, you can specify the following
items.
• Block Length: 15.0 mm, 5.0 mm - 300.0 mm
• # of Blocks: 4, 1 - 99
• Separator:
(Line),
(Bold),
• Orientation:
• Reverse: Off, On
• Advanced: Off, On
Adjust block length independently when "Advanced" is set to "On".
• No Margins: Off, On
Set the left and right label margins to zero.
"Advanced" and "No Margins" cannot be set to "On" at the same time.
(Horizontal),
Flag
Cable
Flag
length
circum-
length
ference
(Tic),
(Dash),
(Frame),
(Horizontal),
1A-B01 1A-B02 1A-B03
Block length
Block length
1. Flag at least 5 mm
(Vertical)
Vertical
Flag
Cable
length
circum-
ference
is selected in flag layout.
(None)
(Vertical)
Block length
Selecting a Labeling Application Type
1
Flag
length
33