Brother QL-1110NWB 빠른 설정 매뉴얼 - 페이지 4

{카테고리_이름} Brother QL-1110NWB에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother QL-1110NWB 9 페이지.
Brother QL-1110NWB에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (9 페이지), 매뉴얼 (2 페이지)

페이지 인쇄

Thread the DK Roll through the printer.

• Align the edge of the DK Roll with the upright edge of the Label Output

Slot.

• Check that the DK Roll is threaded straight so that the labels will not be

skewed.

• Push the first label through the Label Output Slot until the end comes

out of the Slot as shown.

NOTE

If you have difficulty inserting the front of the roll, simple insertion is possible by

inserting from the side under the sensor (1).

Close the DK Roll Compartment Cover.

IMPORTANT

• Do not leave any printed labels in the printer. Doing so will cause the labels to jam.

• When not in use, remove any DK Rolls from inside the printer and close the DK Roll Compartment Cover to prevent

dust and debris from accumulating in the printer.

5. Turn Power On/Off

On: Press the Power ( ) Button to turn the printer On. The Status LED turns green.

IMPORTANT

Press the Feed ( ) Button to align the end of the DK Roll.

Off: Press and hold the Power ( ) Button again to turn the printer Off.

IMPORTANT

When turning the printer Off, do not disconnect the AC Power Cord until the orange Status LED turns Off.