Brother QL-1110NWB Руководство по быстрой настройке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по быстрой настройке для Изготовитель этикеток Brother QL-1110NWB. Brother QL-1110NWB 9 страниц.
Также для Brother QL-1110NWB: Руководство по быстрой настройке (9 страниц), Руководство (2 страниц)
Печатать страницу
4.
Thread the DK Roll through the printer.
• Align the edge of the DK Roll with the upright edge of the Label Output
Slot.
• Check that the DK Roll is threaded straight so that the labels will not be
skewed.
• Push the first label through the Label Output Slot until the end comes
out of the Slot as shown.
NOTE
If you have difficulty inserting the front of the roll, simple insertion is possible by
inserting from the side under the sensor (1).
5.
Close the DK Roll Compartment Cover.
IMPORTANT
IMPORTANT
• Do not leave any printed labels in the printer. Doing so will cause the labels to jam.
• When not in use, remove any DK Rolls from inside the printer and close the DK Roll Compartment Cover to prevent
dust and debris from accumulating in the printer.
5. Turn Power On/Off
On: Press the Power ( ) Button to turn the printer On. The Status LED turns green.
IMPORTANT
IMPORTANT
Press the Feed ( ) Button to align the end of the DK Roll.
Off: Press and hold the Power ( ) Button again to turn the printer Off.
IMPORTANT
IMPORTANT
When turning the printer Off, do not disconnect the AC Power Cord until the orange Status LED turns Off.
1