Brother Stampcreator PRO SC2000USB 빠른 참조 - 페이지 28

{카테고리_이름} Brother Stampcreator PRO SC2000USB에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Stampcreator PRO SC2000USB 36 페이지.

a With the cap on the stamp, place it face down.

☞ If the packing board has been removed, put it back into the stamp.

b Place the skirt over the top of the stamp and push it down firmly.

c Place the grip over the skirt and push it down firmly so that the

fasteners hook onto the tabs and the ink bag inside the stamp breaks.

d Keep the stamp facing down to speed up the flow of the ink.

☞ The length of time that you must wait before the ink begins to flow

from the stamp depends on many factors, such as the size of the

engraved area and the room temperature.

Keep the stamp covered when it is not being used.

Even after the stamp is engraved, it can be corrected using the stamp correction pen to seal any undesired area in the

stamp so that ink will not flow through it.

a With the cap on, hold the enclosed stamp correction pen upright and

shake it well.

b Remove the cap and press the tip of the pen down onto a piece of

scrap paper until ink appears.

c Make a test stamp, and then use the pen to fill in any undesired areas

in the surface of the engraved stamp.

☞ Do not try stamping until the correction fluid is completely dry.

Be sure to apply plenty of correction fluid to the areas that you

wish to fill in.

Keep the cap on the stamp correction pen when it is not being

used.

☞ You can also use the correction pen to make corrections if ink has

run from the space between the glossy area and the non-glossy

area around the printing surface.

☞ When applying the correction fluid, place plenty of fluid on the

area you want to correct like you are making a point with the tip of

the pen, so the tip of the pen does not rub off the area you are

correcting.

Assembling the Stamp

Packing

board

Grip

Skirt

Stamp

Cap