Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 12

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 32 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (29 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (35 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (43 페이지), 구성 매뉴얼 (21 페이지), 구성 매뉴얼 (24 페이지)

Chapter 3

Notes

Note the following issues when connecting the ETERNUS DX/AF to a server.

3.1

To ensure reliable access to ETERNUS DX/AF storage systems, multipath configuration is recommended.

•

Setting up multiple access paths between the server and the ETERNUS DX/AF storage systems, then using

•

the XenServer multipath, provides improved access redundancy.

Enable the virtualization support functions (Intel VT or AMD-V) of the server before installing XenServer.

•

For details on the settings, refer to the relevant manual of the server to be used.

Install XenServer when the ETERNUS DX/AF is not connected to the server.

•

The ETERNUS Multipath Driver does not need to be installed on the XenServer Virtual Machine. The Xen-

•

Server multipath provides path redundancy.

When multiple paths are used, a multipath driver must be set. If a multipath driver is not set, the XenServ-

•

er multipath does not perform proper load balancing for the ETERNUS DX/AF.

Before setting a multipath configuration, create Storage Repositories for all the LUNs that exist in the

•

ETERNUS DX/AF.

3.2

If a path error occurs in a multipath configuration using XenServer, the status of the failed multipath may

•

not be displayed. The status is displayed again when the failed path recovers.

When XenServer is managed and operated with XenCenter, multipath errors may not be detected properly

•

by XenCenter. When checking multipath status, also check the status on the XenServer host side.

3.3

Host Response must be set before the ETERNUS DX/AF is connected to the XenServer host.

•

Even if the Eco-mode of the ETERNUS DX/AF is enabled for a multipath configuration with XenServer, disk

motors may not stop according to the Eco-mode settings.

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix

XenServer

P3AM-4572-19ENZ0