Fujitsu Primergy RX100 S4 서비스 보충 설명서 - 페이지 24

{카테고리_이름} Fujitsu Primergy RX100 S4에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Primergy RX100 S4 43 페이지.
Fujitsu Primergy RX100 S4에 대해서도 마찬가지입니다: 수동 시작 (8 페이지)

페이지 인쇄

Replacing the riser card

4.6

Replacing the riser card

There are two different riser cards (see appendix) available. The spare part

consists of the riser card holder with mounted riser card.

Ê Open the server as described in the

Figure 8: Removing the riser card holder

Ê Loosen the two knurled screws (see circles).

Ê Remove the riser card holder by pulling upward from the system board.

Ê If controllers have been installed in the PCI slots of the riser card, remove

them (for a detailed description see the Options Guide).

Ê Install the controllers in the PCI slots of the new riser card.

Ê Plug the riser card into the PCI slot of the system board.

Ê Fasten the riser card holder with two knurled screws to the housing's rear

side.

Ê Close the server and connect all power plugs (for a detailed description see

the Options Guide).

section "Preparation" on page

Service Supplement

Replacement routines

17.

RX100 S4