Fujitsu Primergy RX100 S4 Handleiding Service Supplement - Pagina 24
Blader online of download pdf Handleiding Service Supplement voor {categorie_naam} Fujitsu Primergy RX100 S4. Fujitsu Primergy RX100 S4 43 pagina's.
Ook voor Fujitsu Primergy RX100 S4: Handleiding starten (8 pagina's)
Pagina afdrukken
Replacing the riser card
4.6
Replacing the riser card
There are two different riser cards (see appendix) available. The spare part
consists of the riser card holder with mounted riser card.
Ê Open the server as described in the
Figure 8: Removing the riser card holder
Ê Loosen the two knurled screws (see circles).
Ê Remove the riser card holder by pulling upward from the system board.
Ê If controllers have been installed in the PCI slots of the riser card, remove
them (for a detailed description see the Options Guide).
Ê Install the controllers in the PCI slots of the new riser card.
Ê Plug the riser card into the PCI slot of the system board.
Ê Fasten the riser card holder with two knurled screws to the housing's rear
side.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
24
section "Preparation" on page
Service Supplement
Replacement routines
17.
RX100 S4