Fujitsu Primergy RX100 S4 수동 시작 - 페이지 3

{카테고리_이름} Fujitsu Primergy RX100 S4에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Primergy RX100 S4 8 페이지.
Fujitsu Primergy RX100 S4에 대해서도 마찬가지입니다: 서비스 보충 설명서 (43 페이지)

페이지 인쇄

Attach the slide rails to the right and

left of the rack.

Attach the slide rails to the first and the third holes

from the bottom of the server.

��

Connecting peripheral devices

Peripheral devices, such as the keyboard and mouse, etc., are connected to the server in the following

order.

�

- You can connect the external floppy disk connected for USB to the connector at the front of the server.

- Connect cables with enough allowance for operation while the device is pulled out from the rack.

��

�

Install the server in the rack.

1. Insert the inner rail to the grooves of the

slide rail and slide the server towards the

back.

2. Pressing the locks on the right and left,

slide the server even further and install it

into the rack.

- Be careful not to pinch your fingers or catch any clothing

when sliding the server into the cabinet.

This could cause injury.

- For a first time installation, make sure to slide the server

backward and fix it to the rack securely.

Fasten the server to the rack.

If the server or peripheral devices are not installed, install

the attached blank panel to the rack.

��

�

��