Fujitsu Primergy RX100 S4 수동 시작 - 페이지 4

{카테고리_이름} Fujitsu Primergy RX100 S4에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Primergy RX100 S4 8 페이지.
Fujitsu Primergy RX100 S4에 대해서도 마찬가지입니다: 서비스 보충 설명서 (43 페이지)

페이지 인쇄

l After connecting the power cable

Pass the supplied release tie through the clamp put up in preparation for the rear of the server.

Afterwards, bind the power cable with release tie.

As a result, even if the power cable comes off unexpectedly, the loss can be prevented.

When plugging off the cable, make sure to unplug the connector at the server end.

Make the circle by passing tie

ahead in the box. Afterwards,

tighten by pulling it.

Turning on the power and setting hardware

Normally, hardware settings are not required to be changed from the default.

However, in the following cases, start each utility and check/change hardware settings.

��

"Chapter 8 Configuring Hardware and Utilities"

l BIOS Setup Utility

Change the settings in the following cases:

- When changing the drive to start the server

- When installing/removing optional devices

- When performing remote installation

You can write down hardware configuration and setting values of the BIOS Setup Utility in the "Configuration Sheets" that is

available from Fujitsu PRIMERGY website (http://primergy.fujitsu.com).

Turn on the power supply of the pe-

ripheral devices, such as the display.

Turn on the power and insert the

ServerStart Disc 1 CD-ROM immedi-

ately.

1. Press the power switch on the front of the

server with a penpoint or thin object.

2. Press the CD-ROM eject button, and insert

the ServerStart Disc 1 CD-ROM.

��

Power cable

Clamp

Release tie

��

Set the hardware.

If no hardware settings are performed, skip to the

next step when a message to insert the ServerStart

floppy disk is displayed.

BIOS Setup Utility

1. When the " <F2> BIOS Setup / <F12>

Boot Menu" message appears at the server

startup (during POST), press the [F2] key.

2. Check/change the settings.

3. Select "Save Changes & Exit" from the

Exit menu and press the [Enter] key.

For the use of Linux distribution with this server, refer to

Fujitsu PRIMERGY website(http://primergy.fujitsu.com).