Fujitsu PRIMERGY RX200 S6 서비스 보충 설명서 - 페이지 34

{카테고리_이름} Fujitsu PRIMERGY RX200 S6에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY RX200 S6 50 페이지.

Replacement routines

4.5

Replacing the HDD backplane

The following description applies to both variants of HDD backplanes (6x

HDD modules or 8x HDD modules).

Removing the defective HDD backplane

Ê Open the server as described in the

page

23.

Ê Remove all HDD modules (see the Operating Manual).

CAUTION!

Ensure that all HDD modules are uniquely identified so that you can

reinsert them into their original bays after replacing the HDD

backplane.

Figure 14: Removing the HDD backplane

Ê Disconnect all cables from the HDD backplane (see circle).

Ê Lift the HDD backplane over the metal bars (see arrows) and then remove it.

Installing the new HDD backplane

Ê Place the new HDD backplane on the metal bars (see arrows in

and press it down carefully.

Ê Reconnect the cables to the HDD backplane (see the cabling plans in the

Appendix of the Options Guide).

Ê Reinstall all HDD modules (see the Operating Manual).

section "Opening/closing the server" on

Service Supplement

figure

14)

RX200 S6