Fujitsu PRIMERGY TX150 S6 서비스 보충 설명서 - 페이지 19

{카테고리_이름} Fujitsu PRIMERGY TX150 S6에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX150 S6 45 페이지.
Fujitsu PRIMERGY TX150 S6에 대해서도 마찬가지입니다: 사용 시 참고 사항 (8 페이지)

페이지 인쇄

Replacement routines

Ê Remove the rack front cover to the front.

Ê Disengage the three tabs on the top side one after the other and pull out the

plastic front cover frontward about 2 cm.

Ê Press the three hooks on the bottom side downward and pull out the plastic

front cover frontward.

4.2

Replacing the operating panel module

Ê Open the server and remove the front cover / rack front cover as described

in the

section "Preparation" on page

Figure 2: Removing the operating panel module

Ê Press the two metal tongues of the EasyClick rails inward (1) until the locking

mechanism is released.

Ê Pull the operating panel module forward out of its mounting location (2) until

you can remove the cables (ribbon cable, USB cable and perhaps

ServerView Local Service Panel cable) from the operating panel board.

Remove the cables.

Ê Pull the operating panel module out of its bay as far as it is possible to get

access to the cable tie.

Ê Thread the cables through the cable tie.

Ê Take the operating panel module out of its bay.

TX150 S6

Replacing the operating panel module

17.

Service Supplement