Fujitsu PRIMERGY TX150 S6 Dodatkowa instrukcja serwisowa - Strona 19
Przeglądaj online lub pobierz pdf Dodatkowa instrukcja serwisowa dla Serwer Fujitsu PRIMERGY TX150 S6. Fujitsu PRIMERGY TX150 S6 45 stron.
Również dla Fujitsu PRIMERGY TX150 S6: Uwagi dotyczące używania (8 strony)
Drukuj stronę
Replacement routines
Ê Remove the rack front cover to the front.
Ê Disengage the three tabs on the top side one after the other and pull out the
plastic front cover frontward about 2 cm.
Ê Press the three hooks on the bottom side downward and pull out the plastic
front cover frontward.
4.2
Replacing the operating panel module
Ê Open the server and remove the front cover / rack front cover as described
in the
section "Preparation" on page
Figure 2: Removing the operating panel module
Ê Press the two metal tongues of the EasyClick rails inward (1) until the locking
mechanism is released.
Ê Pull the operating panel module forward out of its mounting location (2) until
you can remove the cables (ribbon cable, USB cable and perhaps
ServerView Local Service Panel cable) from the operating panel board.
Remove the cables.
Ê Pull the operating panel module out of its bay as far as it is possible to get
access to the cable tie.
Ê Thread the cables through the cable tie.
Ê Take the operating panel module out of its bay.
TX150 S6
Replacing the operating panel module
17.
1
Service Supplement
1
19