Fujitsu SPARC Enterprise M3000 제품 노트 - 페이지 32

{카테고리_이름} Fujitsu SPARC Enterprise M3000에 대한 제품 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SPARC Enterprise M3000 42 페이지.
Fujitsu SPARC Enterprise M3000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (8 페이지), 제품 노트 (38 페이지), 안전 및 규정 준수 매뉴얼 (34 페이지)

페이지 인쇄

XCP Issues Fixed in Releases Earlier Than XCP

TABLE 6

Description

RTIF1-

In a domain mounted with the 10 Gigabit

090508-001

Ethernet card (SE0X7HE1F), when you set the

OpenBoot PROM environmental variable

diag-switch? to true, the following

warning message appears on the console; and

at the same time, "Msg: Device error

(FCode informed error)" is recorded in

the error log.

WARNING: /pci@7,700000: FCODE map-

in doesn't match decoded register

type;

And when you execute the showstatus(8)

command, "Degraded" might be indicated to

the FRU which has installed the relevant card.

RTIF1-

When you use the sethttps(8) command to

090729-001

create a self-signed web server certificate, if

the number of characters specified in a

parameter exceeds 100, it might result in an

internal error and you might fail to create the

certificate.

RTIF1-

The XSCF might go down and require a

090824-001

reboot, or you might see console error

messages and a core dump

(ereport.chassis.software.core) when

one of these conditions occurs:

• A local account has been created with a user

ID explicitly assigned to a value larger than

65536 (adduser -u uid).

• An LDAP account has been used that has a

UID value larger than 65536.

RTIF1-

While Active Directory is enabled, if you log in

091021-001

to XSCF using the user name that registered in

the Active Directory server, the

showconsolepath(8) command displays not

the log-in user name but "proxyuser."

RTIF1-

The loadcert console operand is missing in

091105-001

the usage of the setad(8) command and the

setldapssl(8) command.

RTIF1-

Once domain detected a failure related to

091109-001

DIMM or PCI, the error log about this detected

failure is registered every time you reset XSCF.

SPARC Enterprise M3000 Server Product Notes for XCP Version 1093 • July 2010

1093

(Continued)

Workaround

The entire output can be safely ignored.

To avoid these outputs, execute the following

command at the ok prompt and set the

OpenBoot PROM environmental variable

diag-switch? to false.

setenv diag-switch? false

Specify up to 100 characters in the parameter

and execute the sethttps(8) command again.

Use only user accounts with a user ID (UID)

value between 100 and 60000. This is the range

of auto-assigned UIDs for the XSCF command

adduser(8).

No workaround is available.

For how to use the loadcert console

operand of the setad(8) command and the

setldapssl(8) command, see the man page.

This error log can be safely ignored.